Weld Mount

The AT-5 tie mount is designed to be set into wet resin during the hull lay up or bonded with our acrylic adhesives. It's designed for a #5 wire ti...

AT-850 tip is for use with: AT-2010 AT-8040 It’s unique design eliminates any possibility of the cartridge plugging up as the entry is separa...

The AT-3 tie mount is smaller for panel and other small space applications. This part is molded in white nylon and is sized for a #3 wire tie with ...

Weld Mount AT-8040 is a solvent free, VOC Compliant, two part methacrylate-based, structural adhesive formulated to bond metals for use in severe e...

These small panel studs have a wide range of uses. Originally they were used for mounting on the backside of dash panels or for mounting to the con...

Weld Mount AT-880 is the newest adhesive in the Weld Mount System.  It is designed to bond plastics, metals and rubbers; which have been challengin...

The AT-65100 Adhesively Bonded Fastener Kit Has a Variety Of Weld Mount Parts Designed To Give The User The Chance To Try Our Weld Mount System At ...

AT-858 tip is for use with: AT-880 It’s unique design eliminates any possibility of the cartridge plugging up as the entry is separated.  This pr...

Floating nut plates are designed for thru hole and blind mounting applications. The rubber fixture holds the part in place while it is bonded in pl...

The AT-388 Adhesive dispensing gun comes with a 10:1 plunger. For Use With 50mL Cartridges of: AT-880 Note: The AT-388 will ONLY work with the AT...

This tie mount is provided with an anodized aluminum base with a nylon tie mount which is riveted to the base. The nylon mount swivels 360 degrees ...

Used with Stainless Steel or Nylon wire ties up to “0.35” inches wide.  50 lbs. tensile strength when bonded with AT-6030 adhesive.  Manufactured o...

The AT-1001003 Executive Adhesive and Fastener Kit Contains A Large Selection Of All The Common Weld Mount Parts And Is An Ideal Kit For The Full S...

The AT-301 Adhesive dispensing gun comes with a 10:1 plunger. For Use With 50mL Cartridges of: AT-6030 Note: The AT-301 will ONLY work with the A...

The AT-300 Adhesive dispensing gun comes with a 1:1 plunger. For Use With 50mL Cartridges of: AT-2010 AT-8040 Note: The AT-300 will not work ...

AT-7001 Industrial Fastener Kit Contains A Large Selection Of All The Common Weld Mount Parts And Is An Ideal Kit For Industrial Maintenance Shops....

AT-6030 is a 10 to 1 metal bonding adhesive. It has high viscosity and cures in 10 - 12 minutes, has a 6 minute working time and develops working s...

Used with Stainless Steel or Nylon wire ties up to 0.4 inches wide. 250 lbs tensile strength when bonded with AT-6030 adhesive. Manufactured of 505...

Weld Mount cable and hose clamps are available as single or double units. Each is designed to be mounted using our ¼" x 20 Weld Mount studs. The ch...

Weld Mount stainless steel female threaded standoffs mount to virtually any surface. These standoffs are .75” tall with a 1.25” diameter base. Like...

The HS200 stud is designed for heavy load applications such as mounting filters and panels. The stud is inertial (friction) welded to a 2" base pla...